/nas/content/live/asigloballiveh/wp-content/themes/ASIAccurate/single.php

Guides & Insights
Can Bathroom Partitions Be Custom Sized?

Bathroom partitions can be custom sized. Manufacturers cut panels, doors, and pilasters to field-verified dimensions for rooms that don’t match standard stall widths, including irregular alcoves, angled walls, and layouts interrupted by columns. Our custom partition specification page outlines the field measurements needed to quote a custom order.

When Do You Actually Need a Custom Size?

You need a custom size any time a standard stall width doesn’t physically fit the space. Standard and wheelchair-accessible compartments come in common stock widths, but an irregular room frequently falls between those sizes or can’t hold the clearance an accessible compartment needs.

Four Common Triggers for Custom Sizing

  1. An alcove or recessed area narrower or wider than standard framing
  2. A structural column intruding into a planned stall bay
  3. An angled wall from an unusual building footprint
  4. A ceiling height that doesn’t match standard pilaster or panel heights

Renovation projects hit these triggers far more often than new construction, since the room already exists and the partition has to adapt to it.

How Does Custom Sizing Actually Work?

Custom sizing works the same way a standard order works, except the cut dimensions come from field measurements instead of a size chart.

What Stays the Same

The core hardware, hinges, latches, and brackets, stays identical across standard and custom orders. Only the panel, door, and pilaster dimensions change, which means custom sizing means custom cutting, not custom engineering.

Does Custom Sizing Affect ADA Compliance?

Custom sizing can meet or exceed ADA clearance minimums even in an oddly shaped room, since ADA stall dimensions set a floor, not a fixed size.

What Custom Sizing Cannot Do

Custom sizing cannot shrink a stall below the applicable ADA clearance minimum to force an awkward space to work. If a room can’t physically accommodate the clearance an accessible layout calls for, that’s a layout problem custom sizing won’t solve on its own.

Does Custom Sizing Add to the Timeline?

Yes. Custom orders take longer than stock orders because nothing gets cut until field measurements are verified, and the panels, doors, and pilasters are then made to those dimensions rather than pulled from stock.

The added time comes from two steps: field verification before cutting, and the non-stock fabrication itself. Confirm current lead times with the supplier when you request the quote, since they shift with material availability and production schedule.

Related Partition Sizing Questions

How Do You Get the Field Measurements a Custom Order Needs?

Custom sizing is only as accurate as the measurements behind it. How to Measure for Bathroom Partitions covers the five measurements every order, standard or custom, depends on.

Does a Renovation Always Require Custom Sizing?

Not always, but renovations change the odds significantly. Can You Reuse Bathroom Partitions in a Renovation? covers how an existing layout affects the standard-versus-custom decision.

Frequently Asked Questions

Is Custom Sizing More Expensive Than Standard?

Usually somewhat, due to field verification and non-stock cutting, but the difference is typically smaller than the cost of reordering a stock size that doesn’t fit.

Can You Custom Size Just One Stall in an Otherwise Standard Run?

Yes. It’s common to custom size a single end stall around a column or alcove while the rest of the run uses standard dimensions.

Do Custom Sizes Still Use Standard Hardware?

Yes. Hinges, latches, and brackets are the same components used in stock orders.

ASI Global Partitions reserves the right to make design changes or to withdraw any design without notice.